RS485 Links Specifications
| Optical Parameters @ Maximum Temp | Multimode | Single-Mode | | Optical Budget Typical | 19.5 dB | 19 dB | | Output power Typical | -10.5 dBm peak | -14.5 dBm peak | | Receiver Sensitivity Typical | -30 dBm peak | -33.5 dBm peak | | | (62.5µ/125 Multimode) | (9µ/125 Single-mode) | | Wavelength | 850nm | 1310nm | | Connector Type | ST | | Compatible Fiber Type | Multimode (50-200µm) | Single-Mode (9-13µm) | | Configuration (Switches) | Half/Full Duplex | | | Data Inversion Mode | | | AC/DC Coupled | | | Link/Repeat | | | Bias Resistors In/Out | | | Enable Holdover Timing | | | Diagnostic Mode | | Data Rate | DC to 200 Mbps | | Data Transmission | Asynchronous, simplex or Full Duplex | | Transmission Distance | up to 5000 meters
(62.5µ/125 Cable@3dB/km) | up to 30K meters
(9µ/125 Cable@0.5dB/km) | | Bit Error Rate | 10-E9 Max. | | Point to Point Latency | 500 nsec Max | | Repeat Latency | 400 nsec Max | | Electrical Parameters | | Inputs | | I/O Data Format | EIA 422; EIA 485 | | Data Connector | 9 pin D-Type Female | | Input Impedance | 750 Ohms | | Input Voltage | -7 V to +12 V max on each line; +/- 6 V Max differential | | Outputs | | Output Impedance | 250 Ohms | | Driver Output | 50 mA | | Ambient Temperature | | Operating Temperatures | -40 to +85 C | -40 to +70 C | | Storage Temperature | -40 to +85 C | | Power Required | | 5846 | 6.0 Watts | 8.0 Watts | | | 45 mA @ 90-250 V | 60 mA @ 90-250 V | | | 250 mA @ 18-60 V | 340 mA @ 18-60 V | | 5845 | 3.0 Watts | 4.0 Watts | | | 250mA @ 12Vdc | 340mA @ 12Vdc | | Power Dissipation BTU/H | | 5846 | 20 BTU | 27 BTU | | 5845 | 10 BTU | 14 BTU | | Physical Parameters | | Weight | | 5846 | 17 Ozs. | 17 Ozs. | | 5845 | 9 Ozs. | 9 Ozs. | | Dimensions Inches | | 5846 | 4.1W X 5.1L X 1.3H | | 5845 | 2.0W X 5.1L X 1.3H | | Indicators | Power | | | Transmit Fiber | | | Transmit Electrical | | | Receive Fiber | | | Receive Electrical | | Specifications Subject to Change Without Notice | |
